Solace Pro 2 working on an ESP32

General
1

Hello everyone,

I’m working on a small project to get a Keon and a Solace Pro 2 working on an ESP32. Using reverse engineering, I managed to get the Keon working on an ESP32.
But with the Solace Pro 2, I’m essentially stuck. I can connect to the Solace, but when I enter a position, the Solace is no longer connected.
So there’s something in between that I can’t figure out. It could be some special handshake verification, a custom authentication protocol, or something the GATT service handles.

I can’t figure it out. Perhaps someone can point me in the right direction.

thanks all

2

There’s no handshake for Lovense toys, but we don’t really do embedded so we’ve not going to be able to give any more advice than “take a look at what out protocol code does”.

3

Thanks i understand :wink: i go look